Five checkpoints drawn from the Diecast Basics articles. Read them next to the shelf, then open the section for the full reasoning.
01Definition
Zinc alloy is poured or injected into a mould to form the body, which gives weight and a crisp outer shape.
02Look for
Most resin models are sealed, with no opening doors or bonnet, because the material is more brittle at thin hinges.
03Common mistake
Sink marks sit above internal mounting points and show as shallow depressions on otherwise flat panels.
04Record
On sealed models the line is cast rather than cut, so it is a shape cue rather than a working joint.
05Cross-check
Support the panel with two fingers near the hinge and never force a stiff joint to move.
Scope noteMaterials and finishes vary between ranges and production years. This section describes general construction choices and inspection habits, not a ruling on any particular model or maker.
